Welcome, we are going to show you how to set up the autopilot settings in WipeQ

Now a lot of times using WipeQ you will need to set a default order and will potentially need to have a couple of settings that are automatically set every time a computer boot.

For example, would be work a specific order with 1000 computers and do not want your employees to waste time setting order and grade and specifics for each boot. And if that is the case you will want to set up the autopilot settings.

Navigate to settings, located in the left-hand side panel. On the settings page, you will click over to autopilot settings.

On autopilot, you can have it Auto Wipe to drive on a boot which will have to be manually enabled.

You have an option to set up a default order. Select the industry you are defaulting for all the boots.

You will select a default wipe and indicate default work instructions, for operators to view.

Below you will have the ability to default a specific grade.

To complete your default, you must enable the order and grade sections and click save.

Once saved, the next time a computer boots to the system it will auto default in client processing. A grade will be preset and the defaults that were saved will show appropriately.

Browser not supported